Sudo bash -c "cat > /etc/init/nf" <<'EOF' The following commands create nf with the upstart code to run wakeonlan (as per example above), set the file to exectuable, and start the service : To have an application or service is running on startup, Ubuntu uses Upstart scripts which replace the old init scripts. Note: "g" indicates wake on Magic Packet is enabled.Supported link modes: 10baseT/Half 10baseT/Full Run the following command to enable it on ethX (where X is the Ethernet device number). Sudo apt-get install ethtool 2.2 Setup ethtool WOL options One of the easiest applications to use to enable Wake-On-LAN is ethtool. ![]() One must tell Ethernet controller to WOL when boots up and tell "halt" script not to bring down controller during shut-down. Even if you see the Ethernet port LED is on after the halt/shutdown, the OS shuts off the Ethernet internally. 4.3 Using the Kodi remote control iOS appįirst of all, the motherboard should support Wake-On-LAN and it should be enabled in the BIOS.ĭifferent BIOSs and motherboards do this differently for example on the ASUS P5N7A-VM, it's under Power > APM Configuration and in there Resume On PCIE Wake and Resume On LAN(MAC) should be enabled.Įven though Wake-On-LAN works in network layer 2, OS support is still one of the important things to make it work.4.2 Suspend or Hibernate from command line.
0 Comments
Leave a Reply. |